 |
| Power valve was coated in nearly 2mm of carbon and jammed solid. |
 |
| The wire-wheel cleaned it up pretty good. |
 |
| Got a new dust-seal from BDK Engineering as it is almost impossible to remove the old one without wrecking it. Dust seal link - http://bdkraceeng.co.uk/tc/products.php?144 |
 |
| I also began grinding the exhaust port in the barrel to remove the ridges left either side from the casting and knife-edge the centre-divider. I will also have a crack at the inlet port in the crankcase before it goes back together. |
No comments:
Post a Comment